Communication Setup

1	Determine the Axis ID of a drive connected over RS232 [GB/CM] EasyMotion Studio and Easy SetUp are able to automatically determine the axis ID of the drive connected to the PC via RS232. This feature is enabled when the Axis ID of drive/motor connected to PC option from Communication Setup dialog is set to autodetected.…
2	Possible causes of the communication failure between PC and Technosoft drives [GB] Below are presented the most frequent causes for communication errors reported by EasyMotion Studio: 1. Communication port is not working properly. > Solution: Check the communication port settings. 2. Drive gets reset by the power supply voltage drop.…
3	Default RS232 communication baud rate details The default RS232 communication baud rate used by the Technosoft drives after Power ON / Reset is 9600 bps. When EasySetUp or EasyMotion Studio is configured to use RS232 to communicate to the drives, it scans all possible baud rates in sequence. Once communication…